The short version of CJC-1295 fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-11-28 and is reviewed periodically as new material appears.
Pharmacokinetic behaviour differs sharply between the two forms. The DAC-bearing peptide shows an extended circulation time measured in days, whereas the version without the complex is cleared within roughly half an hour. This gap shapes how researchers design dosing schedules in animal models. Whether the prolonged presence of the DAC form produces effects meaningfully different from the short-acting variant remains an open question, since comparative human data are scarce.
CJC-1295 is a synthetic peptide designed to mimic growth hormone-releasing hormone (GHRH), the endogenous signal that prompts the pituitary gland to release growth hormone. The compound is a modified fragment of the natural hormone, spanning the first twenty-nine amino acids of GHRH with several substitutions that slow enzymatic breakdown. Two variants circulate in research settings: one carrying a drug affinity complex (DAC) and one without it. The DAC-free form is frequently labelled Mod GRF(1-29) in catalogs and discussion forums.
Lyophilized peptide powder is comparatively stable when kept dry, cold, and protected from light. Once dissolved, the molecule is vulnerable to deamidation, oxidation, and aggregation, with the rate depending on pH, buffer composition, and temperature. Alkaline conditions and repeated freeze-thaw cycles accelerate loss of the intact peptide. The methionine present in the native sequence is a known oxidation site, which is one reason it was replaced in the modified fragment. Suppliers typically recommend cold storage of solutions and use within a short window.
Analytical confirmation usually relies on reversed-phase high-performance liquid chromatography for purity and on liquid chromatography coupled to mass spectrometry for identity. Mass data reveal the expected molecular mass and can flag truncated or oxidized species. Amino acid analysis and peptide mapping provide sequence-level verification. Immunoassays are used in some biological matrices, but antibodies raised against one releasing-hormone analog may cross-react with another. Reported purity figures depend heavily on the method used, so comparisons between suppliers require matching the analytical approach.
The two variants differ dramatically in how long they persist in circulation. The form lacking the albumin-binding group has a plasma half-life measured in tens of minutes, comparable to the natural hormone fragment. The version carrying the drug affinity complex binds albumin and shows a half-life of roughly six to eight days in human studies. That figure comes from small trials that tracked hormone levels over extended periods. The physiological consequences of sustained versus pulsatile stimulation are still debated and the literature does not settle the point.
| Property | Value | Notes |
|---|---|---|
| Molecular weight (with DAC) | ~3647 Da | Calculated from the full amino acid sequence |
| Molecular weight (without DAC) | ~3368 Da | Mod GRF(1-29) variant |
| Appearance | White lyophilized powder | Typical form supplied for research |
| Solubility | Soluble in water | Dissolves in aqueous buffers |
| Receptor target | GHRH receptor | Expressed on pituitary somatotroph cells |
Lyophilized material is typically stored at minus twenty degrees Celsius or lower. Keeping the vial dry and protected from light preserves peptide integrity. Repeated freeze-thaw cycles can cause aggregation or loss of activity. Once dissolved, solutions are generally kept at two to eight degrees Celsius. Stability data for reconstituted solutions vary, and long-term behavior is not fully established. Working aliquots reduce the number of times a stock container is opened.
Reverse-phase high-performance liquid chromatography is the standard tool for purity assessment. The technique separates the target peptide from truncated or modified byproducts. Mass spectrometry confirms molecular weight and supports sequence verification. Electrospray ionization and matrix-assisted laser desorption are both used. Amino acid analysis provides an independent check on composition. Purity values are commonly reported as area percentage from the chromatogram. Residual trifluoroacetate and water content are also measured in many quality programs.
The compound emerged from work at a Canadian biotechnology firm in the early 2000s. Early human studies examined its effect on growth hormone and insulin-like growth factor 1 in healthy volunteers and in people with HIV-associated fat redistribution. Reports described sustained increases in both markers after a single injection. Development did not advance to regulatory approval, and the clinical programme was later discontinued. The molecule is now encountered mainly as a research chemical rather than a marketed medicine.
Two forms circulate in research settings and are frequently confused. One carries the drug affinity complex and is often written as CJC-1295 with DAC; the other lacks that group and is usually called modified GRF(1-29). The two share the same core sequence but differ sharply in how long they persist in blood. Products labelled only as CJC-1295 normally refer to the version carrying the complex. Documentation that omits the distinction leaves the intended molecule ambiguous.
CJC-1295 is a synthetic peptide built as a long-acting analogue of growth hormone-releasing hormone. Its backbone matches the first twenty-nine residues of the natural human hormone, with four amino acid substitutions added to slow enzymatic breakdown. A reactive maleimide group, commonly termed the drug affinity complex, allows the peptide to attach to circulating albumin after administration. That albumin attachment keeps the molecule in the bloodstream for an extended period instead of being cleared within minutes.
CJC-1295 is a synthetic peptide modeled on growth hormone-releasing hormone, the hypothalamic signal that prompts the pituitary to release growth hormone. Its sequence corresponds to the first twenty-nine residues of human GHRH, with four substitutions that slow enzymatic breakdown. Early descriptions placed the compound in research on growth hormone deficiency and related conditions, and later literature groups it with the long-acting GHRH analogs. The name appears in both laboratory and popular fitness writing, where it sometimes labels chemically different peptides.
Two related peptides circulate under the CJC-1295 label, and they differ mainly in how long they persist in circulation. The version carrying a drug affinity complex includes a maleimidopropionic acid linker that forms a covalent bond with serum albumin. The other version, usually written as modified GRF(1-29) or tetrasubstituted GRF(1-29), lacks that linker and is cleared quickly. Mixing the two produces inconsistent readings of published half-life values, because the linker rather than the receptor-facing sequence drives most of the difference.
The core sequence keeps the receptor-binding region of GHRH while replacing four positions that are vulnerable to dipeptidyl peptidase-4 and other proteases. Substitutions at positions 2, 8, 15, and 27 raise metabolic stability relative to the natural hormone. The N-terminal residues remain essential for activity, so changes there generally lower potency. Molecular weight sits near 3368 daltons for the tetrasubstituted analog without the linker, while the albumin-binding form is heavier because of the added maleimide group.
== Limitations == Although the Ka/Ks ratio is a good indicator of selective pressure at the sequence level, evolutionary change can often take place in the regulatory region of a gene which affects the level, timing or location of gene expression. Ka/Ks analysis will not detect such change. It will only calculate selective pressure within protein coding regions. In addition, selection that does not cause differences at an amino acid level—for instance, balancing selection—cannot be detected by these techniques. Another issue is that heterogeneity within a gene can make a result hard to interpret. For example, if Ka/Ks = 1, it could be due to relaxed selection, or to a chimera of positive and purifying selection at the locus. A solution to this limitation would be to apply Ka/Ks analysis across many species at individual codons. The Ka/Ks method requires a rather strong signal in order to detect selection. In order to detect selection between lineages, then the selection, averaged over all sites in the sequence, must produce a Ka/Ks greater than one—quite a feat if regions of the gene are strongly conserved. In order to detect selection at specific sites, then the Ka/Ks ratio must be greater than one when averaged over all included lineages at that site—implying that the site must be under selective pressure in all sampled lineages. This limitation can be moderated by allowing the Ka/Ks rate to take multiple values across sites and across lineages; the inclusion of more lineages also increases the power of a sites-based approach.
The production of 293Og and its daughter 289Lv, as well as the even heavier isotope 297Og, is also possible using this reaction. The isotopes 295Og and 296Og may also be produced in the fusion of 248Cm with 50Ti projectiles. These heavier and likely more stable isotopes may be useful in probing the chemistry of oganesson. A search in 2017 at RIKEN using this reaction was unsuccessful.
Molecularization was particularly important in genetics, immunology, embryology, and neurobiology, while the idea that life is controlled by a "genetic program"—a metaphor Jacob and Monod introduced from the emerging fields of cybernetics and computer science—became an influential perspective throughout biology. Immunology in particular became linked with molecular biology, with innovation flowing both ways: the clonal selection theory developed by Niels Jerne and Frank Macfarlane Burnet in the mid-1950s helped shed light on the general mechanisms of protein synthesis. Resistance to the growing influence of molecular biology was especially evident in evolutionary biology. Protein sequencing had great potential for the quantitative study of evolution (through the molecular clock hypothesis), but leading evolutionary biologists questioned the relevance of molecular biology for answering the big questions of evolutionary causation. Departments and disciplines fractured as organismic biologists asserted their importance and independence: Theodosius Dobzhansky made the famous statement that "nothing in biology makes sense except in the light of evolution" as a response to the molecular challenge. The issue became even more critical after 1968; Motoo Kimura's neutral theory of molecular evolution suggested that natural selection was not the ubiquitous cause of evolution, at least at the molecular level, and that molecular evolution might be a fundamentally different process from morphological evolution.
In bioinformatics and evolutionary biology, a substitution matrix describes the frequency at which a character in a nucleotide sequence or a protein sequence changes to other character states over evolutionary time. The information is often in the form of log odds of finding two specific character states aligned and depends on the assumed number of evolutionary changes or sequence dissimilarity between compared sequences. It is an application of a stochastic matrix. Substitution matrices are usually seen in the context of amino acid or DNA sequence alignments, where they are used to calculate similarity scores between the aligned sequences.
Sources: en.wikipedia.org
=== Four Conditions === Oven-dry (OD) is defined as the condition of an aggregate where there is no moisture within any part of the aggregate. This condition can be achieved in a laboratory by heating the aggregate to 220 °F (105 °C) for a period of time. Air-dry (AD) is defined as the condition of an aggregate in which there are some water or moisture in the pores of the aggregate, while the outer surfaces of it is dry. This is a natural condition of aggregates in summer or in dry regions. In this condition, an aggregate will absorb water from other materials added to the surface of it, which would possibly have some impact on some characters of the aggregate. Saturated surface dry (SSD) is defined as the condition of an aggregate in which the surfaces of the particles are "dry" (i.e., they will neither absorb any of the mixing water added; nor will they contribute any of their contained water to the mix), but the inter-particle voids are saturated with water. In this condition aggregates will not affect the free water content of a composite material. The water adsorption by mass (Am) is defined in terms of the mass of saturated-surface-dry (Mssd) sample and the mass of oven dried test sample (Mdry) by the formula:
Some pregnant women and care providers choose to forgo routine screening due to the absence of risk factors; however, this is not advised due to the large proportion of women who develop gestational diabetes despite having no risk factors present and the dangers to the mother and baby if gestational diabetes remains untreated.
Mutation E101K: changes of net charge and formation of a weak electrostatic link in the actomyosin-binding site. P166A: interaction zone between actin monomers. A333P: actin-myosin interaction zone. Pathogenesis appears to involve a compensatory mechanism: the mutated proteins act like toxins with a dominant effect, decreasing the heart's ability to contract causing abnormal mechanical behaviour such that the hypertrophy, that is usually delayed, is a consequence of the cardiac muscle's normal response to stress. Recent studies have discovered ACTC1 mutations that are implicated in two other pathological processes: Infantile idiopathic restrictive cardiomyopathy, and noncompaction of the left ventricular myocardium.
Sources: en.wikipedia.org
The synthetic peptide keeps the receptor-binding region of GHRH but carries substitutions that resist enzymatic cleavage. In the DAC version, an added group also anchors the molecule to albumin, extending its presence in the bloodstream.
The maleimide group forms a covalent link with albumin, an abundant blood protein. This attachment slows clearance, so a single administration persists much longer than the unmodified peptide. The feature is the main reason the two variants are handled differently in study design.
It is not an approved therapeutic product in major regulatory jurisdictions. It appears in research chemical catalogs and scientific literature rather than pharmacy shelves. Clinical development was limited and did not reach approval.
The version carrying the affinity complex bears a maleimide group that binds serum albumin, which extends its circulation time to several days. The version without it lacks this group and clears within roughly half an hour. The two are chemically related but behave very differently once in the body.